What happens when the industry specific hydraulic press stops wo

What precautions should we pay attention to when the industry specific hydraulic press stops working? To ensure the normal operation of the machine, today I will introduce the precautions when the hydraulic press stops working.

一、The industry specific hydraulic press slider stops at the bottom dead center. To prevent mold adhesion and other situations, the height of the slider can be appropriately increased, and then the slider can be stopped at the bottom dead center.

二、Press the main motor stop button, the main motor stops running, and at the same time, the flywheel brake brakes the flywheel until it stops; Stop the lubrication system.

三、Cut off the power supply of the operating four column press and remove the operating switch key; Internal high-pressure forming four column hydraulic press.

四、Cut off the power supply of industry specific hydraulic presses.

五、Close the main air source stop valve and drain the condensate in the air Plumbing.

六、Thoroughly inspect the four column press for any signs of cracking, heating, damage, looseness, etc.

七、Clean up all parts of the industry specific hydraulic press, organize tools and on-site.